http://www.beadingdaily.com/blogs/howto/archive/tags/thread+tips/default.aspxTags: thread tipsenCommunityServer 2008 (Debug Build: 30417.1769)http://www.beadingdaily.com/blogs/howto/archive/2008/05/15/finishing-and-starting-new-thread.aspxThu, 15 May 2008 20:30:00 GMTe599e337-6bb7-4670-8e80-180f614937ac:21Kat0Tie off your old thread when it&#39;s about 4&quot; long by making a simple knot between beads. Pass through a few beads and pull tight to hide the knot. Weave through a few more beads and trim the thread close to the work. Start the new thread by tying...(<a href="http://www.beadingdaily.com/blogs/howto/archive/2008/05/15/finishing-and-starting-new-thread.aspx">read more</a>)<img src="http://www.beadingdaily.com/aggbug.aspx?PostID=21" width="1" height="1">thread tipshttp://www.beadingdaily.com/blogs/howto/archive/2008/05/15/pass-through-vs-pass-back-through.aspxThu, 15 May 2008 20:26:00 GMTe599e337-6bb7-4670-8e80-180f614937ac:14Kat0Pass through means to move your needle in the same direction that the beads have been strung. Pass back through means to move your needle in the opposite direction. See Thread...(<a href="http://www.beadingdaily.com/blogs/howto/archive/2008/05/15/pass-through-vs-pass-back-through.aspx">read more</a>)<img src="http://www.beadingdaily.com/aggbug.aspx?PostID=14" width="1" height="1">thread directionthread tipshttp://www.beadingdaily.com/blogs/howto/archive/2008/05/15/adding-new-thread.aspxThu, 15 May 2008 18:33:00 GMTe599e337-6bb7-4670-8e80-180f614937ac:30Kat0Free Video: How to Add and End Thread When you have about 6&rdquo; of thread remaining, weave it into the beadwork, tying discrete half hitch knots between beads. (Note were you are leaving off so you&rsquo;ll know where to start your new thread.) Trim...(<a href="http://www.beadingdaily.com/blogs/howto/archive/2008/05/15/adding-new-thread.aspx">read more</a>)<img src="http://www.beadingdaily.com/aggbug.aspx?PostID=30" width="1" height="1">thread tips